*630A T Back connector can be use together with the T Fore connector and some other back connector,it can be provide more branches, and they can not together with the bushing directly,cover the back protection cap on the end of the blanking cover,
* For indoor and outdoor installations.
*Continuous operating voltage 8.7/15kV Continuous current 630A; (900A overload for 8 hours)
*Connect to (JBK) coupling connector or (HBLO) surge arrester to enable muli-loop installation or provide over voltage protection,
* Cable particulars;
- Copper or aluminum conductors
- Semiconducting of metallic screens.
- Conductor cross section:12kV 25-500mm2
*Provides a fully screened and fully submersible separable connection when mated with the
proper European separable front connector or European separable
* Can be used under the circumstances.
* Built-in capacitive test point to deter mine the circuit status or install a fault indicator.
* No minimum phase clearance requirements.
* Mounting can be vertical. horizontal, or any angle in between.
——scope of delivery
* T back connector
* Stress cone
* Conductor cable lug (Copper or copper )
* Connect lug
* M16/12 screw stud
* M12nuts.flat washers.spring washers
* Utility Knife
* Surgical tape
* Clean paper
* Silicone grease
* Gloves (white.Yellow)
* Sealant (red)
* Cable ties (snap)
* PVC electrical tape (red,yellow,green)
* Quality Certificate
* Installation instruction sheet
The key words of this product: